Description
【About】 Eapro solar inverter with 50A inbuilt PWM solar charge controller with excellent Charging at low Mains Voltage.
【Technology】 New Generation MOSFET based PWM technology with greater efficiency at lower cost Dynamic Stability.
【Protections】 Eapro off grid solar inverter has protection feature of Over Load, Short Circuit, and PV Reverse Polarity.
【LED Display】 User friendly graphic led panel Display defining working parameter of Power source for load.
【Setting】 Smart battery selection option with indicator, Selector switch of ups/inv & high/ low charging on the front bezel for ease of operation, Enhanced Temperature Protection and more.
【Protection】 Complete protection of short circuit, phase reversal & overload.
【Battery Support】 Eapro 1100VA SUNverter support Tubular, SMF & Flat Plate battery and also supports fully deep discharge batteries.
Features
Eapro 1100VA 12V Off grid solar inverter
Nominal Battery Voltage: 12VDC
Battery Selection Tubular, Flat & SMF
Single phase Solar Inverter
Input Voltage Range (Normal Mode): 100 to 290 VAC+_ 10 VAC
Input Voltage Range (UPS Mode): 180 to 265 VAC+_ 10 VAC
Protections: Over Load, Short Circuit, PV Reverse Polarity
Technical Specifications
Particulars | Description |
BATTERY MODE | |
No Load Current @ Switch OFF | ≤50mA |
No Load Current @ Switch ON | ≤2.2Amp |
Output Voltage @ No LOAD | 230V Nominal |
Full LOAD Output Voltage @ 24VDC | 200 ± 5 Volt. |
Battery Current @ Full LOAD | 62 ± 1 Amp. |
Thermal Management | Temperature Control by Fan |
UPS MODE | |
Low Cut With Phase Match | 180 ± 10V |
Low Cut Recovery With Phase Match | 9-12V Hysteresis from > Low Cut Voltage |
High Cut With Phase Match | 265 ± 10V |
High Cut Recovery With Phase Match | 9-12V Hysteresis from < High Cut Voltage |
Change Over Time From Mains To UPS | ≤ 10msec |
Change Over Time From UPS To Mains | ≤ 10msec |
NORMAL MODE | |
Low Cut With Phase Match | 100 ± 10V |
Low Cut Recovery With Phase Match | 9-12V Hysteresis > Low Cut Voltage |
High Cut With Phase Match | 290 ± 10V |
High Cut Recovery With Phase Match | 9-12V Hysteresis < High Cut Voltage |
Change Over Time From Mains To UPS | ≤ 40msec |
Change Over Time From UPS To Mains | ≤ 10msec |
CHARGING MODE | |
Low Charging Current @ 220V AC (NC) | 12.0 ± 1.0 Amp |
High Charging Current @ 220V AC (HC) | 16.0 ± 1.0 Amp |
Battery Boost Voltage | as per Table ‘A’ |
Float Voltage | 13.6 ± 0.2 Volt |
Reviews
There are no reviews yet.